PSS Hose Barb Plug - PYI Inc.
By A Mystery Man Writer
Description
Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling
PYI Inc. PSS Type A Shaft Seal
PYI Inc. PSS Type C Shaft Seal
PSS installation instructions (low res).pdf - PYI Inc.
PYI Inc Fisheries Supply
These T-Kits enable the installer to tee into the raw water discharge hose and plumb water to the hose barb fitting of the PSS Shaft Seal.
T-Kit
PYI Inc. PSS Type C Shaft Seal
PSS Hose Barb Plug - PYI Inc.
This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 12 knots under power then the PSS Shaft Seal does not require positive
PSS Hose Barb Plug
PSS Maintenance Kits - For 3/4 to 2-3/4 Shafts - PYI Inc.
PSS T-Kit - PYI Inc.
PYI PSS PRO Shaft Seals
PSS Shaft Seal Hose Barb Plug [07-141-8NPSMPLUG ]
PYI Inc. PSS Shaft Seal
from
per adult (price varies by group size)